TOHATSU BFT115A Service Manual page 280

ENGINE COVER/COVER LOCK
R. SIDE COVER BRACKET
Remove the R. side cover bracket (page 6-18).
Remove the E-ring (1) and washer (2) from the side
lock (3).
Remove the side lock from the R. side cover bracket (4)
by pulling down the side lock, while releasing the cover
lock hook spring (5) from the R. side cover bracket hole.
Remove the cover lock hook spring from the side lock.
Remove the two cover lock bushings A (6).
Check the cover lock bushings A for damage and
replace them if necessary.
Apply marine grease to the cover lock bushings A
whole surface and shaft area of side lock.
Assembly is in the reverse order of disassembly.
UNDER COVER FRONT BRACKET
DISASSEMBLY/ASSEMBLY
DISASSEMBLY
Remove the under cover front bracket (page 6-18).
Remove the E-ring (1) and washer (8 mm) (2) from the
lock front shaft (3).
Pull out the lock front shaft from the under cover front
bracket (4).
Remove the cover lock lever (5), two cover lock
bushings A (6), washer (10 mm) (7) and two wave
washers (8).
6-22
(2)
(4)
(3)
(6)
(7)
(8)
(5)
(1)
(6)
(6)
(5)
(3)
(4)
(2)
(1)