MAINTENANCE
Move the remote control lever (1) to the "F" (Forward)
full open position (2).
Check whether the throttle linkage satisfies the
conditions on step 2, 3 and 4 on page 3-10.
Move the remote control lever to the "N" (Neutral) (3)
position and tighten the adjusting nut.
If the throttle cam does not fully open
Remove the linkage pivot (1) of the throttle rod (2) from
throttle plate (3).
Loosen the linkage pivot lock nut (4).
Turn the linkage pivot of the throttle rod until the throttle
link satisfies the conditions on step 2, 3 and 4 on page
3-10.
Temporarily install the linkage pivot to the throttle plate.
Move the remote control lever (5) to the "F" (Forward)
full open position (6).
Check whether the throttle linkage satisfies the
conditions on step 2, 3 and 4 on page 3-10.
Return the remote control lever to the "N" (Neutral)
position (7) and tighten the linkage pivot lock nut.
After tightening the lock nut, check that the throttle cam
side pivot of the throttle rod is not disconnected from
the throttle cam.
3-12
(1)
(3)
"F" (Forward)
(2)
(1)
(3)
(1)
(5)
(7)
"F" (Forward)
(6)
(2)
(4)