TOHATSU BFT115A Service Manual page 83

MAINTENANCE
Remove the three screws (1), plate (2), strainer cup (3)
(1)
and O-ring (4) from the strainer body (5).
Clean the water or sediment in the cup, and if
(2)
necessary, replace the strainer (6).
Install a new O-ring.
Install the strainer body and plate to the strainer cup,
then tighten the three screws to the specified torque.
(3)
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
(4)
(6)
(5)
Install the suspension (1) on the fuel strainer (2).
(5)
Align the center of the screw (3) at the fuel tube C (4)
(2)
(4)
side with the center line (5) of the suspension as
shown.
Connect the fuel tube E (6) to the outlet mark (7) side of
the fuel strainer and fuel tube C (8) to the inlet mark (9)
side.
Install the engine cover.
(3)
(1)
(7)
(6)
(2)
(9)
(8)
3-25