TOHATSU BFT115A Service Manual page 427

CYLINDER HEAD REMOVAL/
INSTALLATION
REMOVAL
• Remove the cylinder head when the engine is cold.
• Be careful not to damage the gasket mating surfaces
of cylinder head and cylinder block.
Turn the crankshaft and set the No. 1 piston at top dead
center of compression stroke (page 3-15).
Disconnect the battery negative (–) cable.
Make sure the remote control lever is in "N" (neutral)
position.
Remove the following:
– Fuel pump (high pressure side)/Vapor separator
(page 5-101)
– Injector base (page 5-98)
– Exhaust manifold (page 5-107)
– Camshaft/rocker arm (page 14-26)
Loosen the ten bolts (1) in the numbered sequence in
two or three steps.
Remove the cylinder head (1), cylinder head gasket (2)
and two dowel pins (3).
CYLINDER HEAD
(1)
2
6
10
7
3
(3)
1
5
9
8
4
(2)
(1)
14-35