TOHATSU BFT115A Service Manual page 49

VIEWED FROM THE LOWER LEFT SIDE:
HARNESS CLIP
(NOTE 1)
UNDER CASE GROMMET C
· Clamp the power trim/tilt motor wire and trim angle sensor wire.
·
Install under case grommet C, aligning the taped end of the power trim/tilt
motor wire harness with the end of under case grommet C.
·
Check that the wires are not interfering with the front lock of the under
cover front bracket.
FRONT LOCK
UNDER CASE
GROMMET C
TRIM ANGLE
SENSOR WIRE
NOTE 1 Harness clip installation
NOTE 2 Hose clamp installation
NOTE 3 Wire harness clip installation
40
KNOCK SENSOR
1P CONNECTOR
HOSE CLAMP
(NOTE 2)
Wires and tube are not
interfering with the
front lock.
Taped end
POWER TRIM/TILT
MOTOR WIRE
SERVICE INFORMATION
HARNESS BAND CLIP
Clamp the main wire harness
and knock sensor wire.
MAIN WIRE
HARNESS
KNOCK
SENSOR WIRE
Viewed from the upper side:
CABLE CLIP
SPIRAL TUBE
Wind the spiral tube around the power
trim/tilt motor wire harness and trim
angle sensor wire.
WIRE
HARNESS CLIP
(NOTE 3)
page 2-28
page 2-32
page 2-34
2-33