TOHATSU BFT115A Service Manual page 648

TRIM/TILT
Install the power tilt motor (1) on the pump by aligning
the projection (2) on the motor with the cutout (3) in the
drive joint with the motor wire (4) facing toward the
manual valve side.
Install and tighten the four bolts (1) to the specified
torque.
TORQUE: 4.9 N·m (0.50 kgf·m, 3.6 lbf·ft)
Apply ATF to a new O-ring (1) and install it on the
cylinder.
Install the oil tank (2) on the cylinder and tighten the
three bolts (3) to the specified torque.
TORQUE: 4.9 N·m (0.50 kgf·m, 3.6 lbf·ft)
Remove the oil tank cap (1). Pour flesh ATF to the
upper limit (2) of the oil tank filler port.
OIL CAPACITY:
0.68 liter (0.72 US qt, 0.6 lmp qt)
Do not overfill with ATF; that will damage the oil seal of
the motor when each rod is compressed.
After filling the oil tank with ATF, bleed air from the
power tilt/trim (without mounting on the outboard motor)
(page 19-37).
Install the oil tank cap and tighten it to the specified
torque.
TORQUE: 2.5 N·m (0.25 kgf·m, 1.8 lbf·ft)
19-36
(4)
(1)
(1)
(2)
(1)
(2)
(1)
(2)
(3)
(3)