TOHATSU BFT115A Service Manual page 558

GEAR CASE (COUNTER ROTATION)
EXTENSION CASE REMOVAL/
INSTALLATION
REMOVAL
Remove the following:
– L. engine under cover (page 6-4)
– R. engine under cover (page 6-10)
– Gear case (page 17-8)
Remove the three bolts (8 × 30 mm) (1) and lower
mount housing (2).
Remove the bolt (6 × 12 mm) (3) and ground terminal
(4).
Remove the self-locking nut (5), bolt (12 × 225 mm) (6)
and two washers (7).
Slightly move the extension case and remove the lower
rubber mount (8) and lower mount collar (9).
Remove the same parts described above from the
opposite side of the extension case, except the bolt and
ground terminal.
• Support the outboard motor securely in order to
prevent the upper mount from being damaged when
the lower rubber mount is removed from the
extension case, which may cause an excessive load
on the upper mount.
Remove the eight bolts (1) and extension case (2).
Take care not to drop the extension case.
Remove the two dowel pins (3) from the extension
case.
Remove the extension case grommet (4).
17-12
(3)
(6)
(9)
(8)
(1)
(4)
(3)
(1)
(2)
(4)
(5)
(7)
(2)