TOHATSU BFT115A Service Manual page 627

Install the lower rubber mount.
– Standard rotation type (page 16-14)
– Counter rotation type (page 17-14)
Remove the chains (1) from the three engine hangers
(2).
Route the connectors (1) into the hole (2) of the under
cover front bracket (3).
Check that the taped end (4) of the power/tilt motor wire
(5) are aligned with the end of the under case grommet
C (6).
Set the groove of the under case grommet C to the
under cover front bracket securely.
Move the front lock (7) by hand and check that the wires
and tube do not interfere with the front lock.
Connect the trim angle sensor 3P connector (1) and
power tilt motor 2P connector (2).
Install the trim angle sensor 3P connector to the upper
side of the connector bracket A (3) and power tilt motor
2P connector to the lower side.
Install the following:
– Gear case
– Standard rotation (page 16-8)
– Counter rotation (page 17-8)
– L. engine under cover (page 6-6)
– R. engine under cover (page 6-11)
– Switch panel cable/indicator wire (page 10-6)
– Engine cover
(1)
(2)
(3)
(2)
(3)
(6)
(5)
(3)
TRIM/TILT
(2)
(1)
(6)
(7)
(4)
(1)
(2)
19-15