Install the dowel pin (10 × 16 mm) (1), dowel pin (14 ×
20 mm) (2) and new mounting case gasket (3) to the
mounting case (4).
Apply engine oil to a new oil pump rubber (1) and install
it to the mounting case.
• Install the oil pump rubber in the correct direction as
shown.
Lower the engine assembly slowly while aligning its
holes (1) with the stud bolts (2) and shift shaft B(3).
Lower the engine assembly slowly onto the mounting
case while aligning the exhaust manifold (4) with the
exhaust guide (5).
• Be careful not to damage the stud bolt threads or
stepped part of the shift shaft B.
• Lower the engine assembly slowly while holding the
engine vertically.
ENGINE REMOVAL/INSTALLATION
(2)
(3)
(1)
(1)
(3)
(4)
(5)
(1)
(4)
(1)
(2)
13-7