TOHATSU BFT115A Service Manual page 272

ENGINE COVER/COVER LOCK
Install the under cover grommet (1) onto the idle
exhaust port (2).
Install the four under cover grommet bosses (3) into the
engine under cover holes (4) securely.
Set the six mud guard clips (5) by aligning the clip holes
of under cover grommet and engine under covers.
Push in the heads of the mud guard clips (1) completely
in the numbered order.
Check that the lip (2) behind the under cover grommet
is completely set on the engine under covers.
• Be sure that the under cover grommet is fully seated
on the engine under covers.
Connect the power tilt switch 3P connector (1).
Install the power tilt switch 3P connector to the electric
parts case (2).
Secure the starter cable (3) and power tilt switch wire
(4) with the harness clip (5).
Install and tighten the flush plug cap (1) to the R. engine
under cover.
Install the front separate cover (page 6-3).
6-14
(2)
(4)
(3)
(2)
5
1
3
(1)
(3) (1)
(5)
(1)
(5)
(1)
6
2
4
(2)
(4)