TOHATSU BFT115A Service Manual page 398

CYLINDER HEAD
CYLINDER HEAD COVER REMOVAL/
INSTALLATION
REMOVAL
Disconnect the battery negative (–) cable.
Shift the remote control lever in the N (neutral) position.
Remove the following:
– L. engine under cover (page 6-4)
– R. engine under cover (page 6-10)
– Direct ignition coils (page 3-17)
Remove the two bolts (1) and R. side cover bracket (2).
Disconnect the CMP sensor 3P connector (1).
Release the harness band clip (2) from the clip bracket
F (3).
Release the main wire harness (1) from the cylinder
head cover (2).
Disconnect the crankcase breather tube (3).
Disconnect the fuel tube B (1) and fuel tube D (2) from
the fuel pump (low pressure side).
• Clamp the fuel tubes before disconnecting them.
14-6
(2)
(3)
(3)
(2)
(2)
(1)
(1)
(2)
(1)
(1)