TOHATSU BFT115A Service Manual page 633

ASSEMBLY
Install the click assist spring (1) and click spring (2),
then tighten the bolt (3).
Apply marine grease to the click spring roller surface.
Apply marine grease to the two tilt stoppers (4) and tilt
arm bushings (5).
Install the tilt arm bushings and tilt stoppers to the
swivel case (6).
Set the tilting bracket (7) to the tilt stoppers.
Insert the L./R. tilt stopper shafts into the tilting bracket
so that the boss (1) of the bracket is facing right and
upward direction, when viewed from the mount frame
installation hole side of the swivel case.
Drive in the spring pin (2) using a commercially
available pin driver (3) until the extrusion length of the
pin is 1 – 2 mm (0.04 – 0.08 in) (4) at the opposite side
of the driven side (5).
• Do not drive in the spring pin more than necessary,
as it will prevent the tilt stopper operation.
Install the two thrust receivers (1), two washers (2) and
two self-locking nuts (3) to the swivel case (4), then
tighten the nuts to the specified torque.
TORQUE: 39 N·m (4.0 kgf·m, 29 lbf·ft)
Install and tighten the three grease fittings (5) to the
specified torque.
TORQUE: 3 N·m (0.31 kgf·m, 2.2 lbf·ft)
Apply marine grease to the thrust receiver sliding
surfaces.
(3)
(1)
(2)
(6)
(5)
(4)
(3)
(1)
(4)
(5)
(1)
(5)
TRIM/TILT
(7)
(5)
(4)
(5)
(2)
(4)
(3)
(2)
19-21