TOHATSU BFT115A Service Manual page 302

CHARGING SYSTEM
Clean the grease or oil from the slip ring (1) of the rotor
using a shop towel.
Install the rotor (2) to the stator (drive end frame) (3).
Install the bearing cover (4) onto the rotor shaft.
Apply grease to the outer circumference of the rear
bearing (1).
Install the wave washer (2) to the rotor shaft (3).
• Be sure that the wave washer is positioned within
the bearing circumference.
Route the four wires (4) through the rear housing holes
(5), then install the rear housing (6) to the stator (drive
end frame) (7).
Install and tighten the two nuts (8) and two rear housing
bolts (9).
7-16
(4)
(5)
(6)
(2)
(3)
(7)
(1)
(2)
(3)
(9)
(8)
(4)
(1)