TOHATSU BFT115A Service Manual page 303

Install the rectifier (1) and bend the wires (2) toward the
rectifier and around the screw holes as shown.
Install and tighten the four screws (3).
• Replace the stator with a new one, if the wires are
broken around the rectifier holes.
Install the brush holder insulator (1) to the brush holder
(2).
Install the IC regulator (3) and loosely tighten the screw
(4 x 6 mm) (4).
• Tighten the screw so that the brush holder does not
move.
CHARGING SYSTEM
(3) (2)
(4)
(2)
(1)
(1)
(3)
7-17