TOHATSU BFT115A Service Manual page 237

CMP SENSOR REMOVAL/
INSTALLATION
Remove the following:
– L. engine under cover (page 6-4)
– R. engine under cover (page 6-10)
Disconnect the CMP sensor 3P connector (1).
Remove the bolt (2), CMP sensor (3) and O-ring (4).
Apply engine oil to a new O-ring and install it to CMP
sensor.
Install the CMP sensor and tighten the bolt.
Connect the CMP sensor 3P connector.
Install the following:
– L. engine under cover (page 6-4)
– R. engine under cover (page 6-10)
KNOCK SENSOR REMOVAL/
INSTALLATION
Remove the intake manifold (page 5-87).
Disconnect the knock sensor 1P connector (1) and
remove the knock sensor (2).
Install the knock sensor and tighten it to the specified
torque.
TORQUE: 31 N·m (3.2 kgf·m, 23 lbf·ft)
Connect the knock sensor 1P connector.
Install the intake manifold (page 5-87).
EOP SENSOR REMOVAL/
INSTALLATION
Remove the fuse/relay junction box (page 10-3).
Disconnect the EOP sensor 3P connector (1).
Remove the EOP sensor (2) and O-ring (3).
Apply engine oil to a new O-ring and install it to EOP
sensor.
Install the EOP sensor and tighten it to the specified
torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
• Always use the torque wrench when tightening the
EOP sensor and do not tighten it more than the
specified torque. It will cause damage to the cylinder
block.
Connect the EOP sensor 3P connector.
Install the fuse/relay junction box (page 10-3).
(1)
(3)
FUEL SYSTEM
(4)
(3)
(2)
(2)
(1)
(1)
(2)
5-119