Starter Cable Removal; Installation - TOHATSU BFT115A Service Manual

STARTER CABLE REMOVAL/

INSTALLATION

REMOVAL
Disconnect the battery negative (–) cable, then the
positive (+) cable from the battery.
Remove the following:
– Under cover front bracket (page 6-18)
– Switch panel cable/indicator wire harness (page 10-
6)
Remove the two bolts (1) and starter cables (+) (2) from
the fuse/relay junction box (3).
Remove the two nuts (1), washer (2) and starter cables
(+) (3) from the starter B terminal.
Remove the harness band clip (4) from the electric
parts case.
Remove the harness band clip (1) from the cable
bracket B (2).
Remove the bolt (3) and ground terminal (4) of the
starter cable (–).
Remove the harness band clip (1) from the neutral
switch bracket (2).
Remove the starter cable (+) 1P connector (3) from the
connector bracket A (4) and disconnect it.
OTHER ELECTRICAL
(1)
(2)
(1)
(2)
(1)
(4)
(2)
(1)
(3)
(3)
(4)
(2)
(3)
(4)
(3)
10-9