Power Tilt Relay/Connector - TOHATSU BFT115A Service Manual

POWER TILT RELAY/CONNECTOR

BRACKET A REMOVAL/INSTALLATION
Disconnect the battery negative (–) cable, then the
positive (+) cable from the battery.
Remove the following:
– Under cover front bracket (page 6-18)
– Switch panel cable/indicator wire harness (page 10-
6)
Disconnect the fuel tube A (1) from the drain tube
holders (2).
Remove the harness band clip (3) from the neutral
switch bracket (4).
Remove the starter cable (+) 1P connector (5) from the
connector bracket A (6) and disconnect it.
Remove the neutral switch 2P connector (1) and power
tilt relay 3P connector (2) from the connector bracket A
(3).
Disconnect the power tilt relay 3P connector.
Release the clamp (1) of the wire clip and remove the
water level sensor 2P connector (2) from the harness
clip bracket E (3).
OTHER ELECTRICAL
(2)
(3)
(4)
(2)
(1)
(3)
(1)
(6)
(1) (5)
(3)
(2)
10-11