TOHATSU BFT115A Service Manual page 676

CONTROLS
Install the cable bracket A (1) to the seal holder (2) and
tighten the bolt (6 x 14 mm) (3).
Attach a piece of tape (4) around the flange area of shift
shaft B (5) as shown.
Apply marine grease to the oil seal lips (6) of the seal
holder.
Install the seal holder onto the shift shaft B slowly and
tighten the two bolts (6 x 20 mm) (7).
• When installing the seal holder, hold the shift shaft B
(6) to prevent it from being disengaged from shift
shaft A.
• If disengage, adjust the shift shaft B alignment (page
20-18).
• If assembled with incorrect alignment, shifting
operation will fail.
Remove the sealing tape from the shift shaft B.
• When removing the tape, check that the oil seal lip is
not turned inside out.
Install the starter cables (1) to the cable bracket A (2) as
shown.
Install the following:
– Shift arm/neutral switch (page 20-10)
– R. engine under cover (page 6-11)
20-14
(6)
(2)
(1)
(1)
(2)
(7)
(5)
(4)
(3)