CYLINDER BLOCK
MATING SURFACE WITH CYLINDER
HEAD WARPAGE
Take care not to damage (scores, scratches, etc.) the
mating surface with the gasket.
Measure the surface warpage using a straight edge (1)
and a feeler gauge (2) as shown.
STANDARD:
0.07 mm (0.003 in) Max
SERVICE LIMIT:
0.10 mm (0.004 in)
If the measurement exceeds the service limit, replace
the cylinder block (page 15-15).
CONNECTING ROD BOLT
Measure the bolt O.D. at the two points as shown and
calculate the difference between the measurements.
STANDARD:
0 – 0.10 mm (0 – 0.004 in)
If the difference exceeds the standard value, replace
the connecting rod bolt (page 15-15).
Measure the O.D. of all connecting rod bolts.
15-40
MEASUREMENT POINTS
(2)
35 mm (1.4 in)
20 mm
(0.8 in)
(1)