TOHATSU BFT115A Service Manual page 655

POWER TILT MOTOR DISASSEMBLY/
ASSEMBLY
DISASSEMBLY
Untape the corrugated tube (1), and pull the tube to the
connector side.
Remove the screw (2).
Pull out the wire holder (3) and the two grommets (4)
from the yoke (5), and move them to the tube side.
Pull out the grommets with care not to damage them.
Remove the two screws (1) from the front bracket (2).
Wrap the armature shaft (3) with a shop towel (4) or
equivalent material to protect, and hold the shaft with
pliers (5).
Pushing the two motor wires (6) toward the yoke (7),
remove the armature/front bracket from the yoke.
• Do
contaminated with oil or grease.
not allow the commutator
(3)
(4)
(2)
(4)
to become
(5)
TRIM/TILT
(1)
(2)
(5)
(7)
(3)
(1)
19-43
(6)