TOHATSU BFT115A Service Manual page 279

Clean the mating surfaces of the engine cover and
engine cover air guide.
Apply
equivalent) to the specified area (1) of the engine cover
air guide.
Installation is in the reverse order of removal.
SIDE COVER BRACKET
DISASSEMBLY/ASSEMBLY
L. SIDE COVER BRACKET
Remove the L. side cover bracket (page 6-18).
Remove the E-ring (1) and washer (2) from the side
lock (3).
Remove the side lock from the L. side cover bracket (4)
by pulling down the side lock, while releasing the cover
lock hook spring (5) from the L. side cover bracket hole.
Remove the cover lock hook spring from the side lock.
Remove the two cover lock bushings A (6).
Check the cover lock bushings A for damage and
replace them if necessary.
Apply marine grease to the cover lock bushings A
whole surface and shaft area of the side lock.
Assembly is in the reverse order of disassembly.
sealant (SHINETSU-SILICONE
ENGINE COVER/COVER LOCK
KE45 or
(2)
(4)
(1)
(1)
(6)
(5)
(3)
6-21