TOHATSU BFT115A Service Manual page 262

ENGINE COVER/COVER LOCK
Install the three collars (1), then loosely install the three
screws (6 x 25 mm) (2) and special bolt (6 x 17 mm) (3).
• Be sure that the special bolt flange is positioned in
the case bolt hole.
Tighten the screws and special bolt in the numbered
order in several steps.
Install the under case grommet band (4) to the under
case grommet (5) and tighten the band securely.
Install the engine cover.
• Be sure that the fuel tube A is not pinched.
L. ENGINE UNDER COVER REMOVAL/
INSTALLATION
REMOVAL
Remove the engine cover.
Remove the six mud guard clips (1) and under cover
grommet (2).
Loosen the two rivet screws (1) and remove the two
harness clips (2).
6-4
(4)
1
4
(1)/(2)
(2)
(1)
(2)
(3)
2
(5)
3
(1)