3.
Adjust right cable length so that the advancer arm 3 is
touched to full close stopper 5 when throttle full close
position, then temporary tighten the lock nut.
4.
Tighten left and right lock nut 6 to tend the throttle cable.
· Adjust throttle cable tension so that it moves
approximately 1 mm when pushed lightly with a
finger.
· Check advancer arm touches to full close
stopper when throttle full close position.
2) Adjusting of Remote Control Cable
For adjusting, refer to "Installation of Remote Control
Cable (Engine Side)" in Chapter 10.
3) Inspection of Idle Engine Speed
1.
Start engine and run for 5 minutes to warm up.
2.
Attach tachometer to high tension cord 1 to check idle
speed.
· More accurate and stable reading can be
obtained when tachometer lead is connected
with high tension cords of individual cylinders
linked with each other.
· Idle engine speed that is set at variable trolling
is maintained. Idle speed is changed by
depressing key switch while idling.
Tachometer :
P/N. 3AC-99010-0
Idle Speed :
700 · 800 · 900 r/min
RPM
TLD D30/40/50B2 2013
3
6
6
6
6
1
1High tension cord
5
3
3-13