Power Tilt Motor; 1） Removal, Inspection And Repair Of Power Tilt Motor; 2）Continuity Test - TOHATSU MFS 9.9 Service Manual

PTT Unit

7.Power Tilt Motor

1）Removal, Check and Repair of Power Tilt Motor
Remove 2 inner hex bolts 1, and then remove motor ass'y
1.
2 from power tilt pump and cylinder ass'y 3.
Before disassembling power tilt motor, drain power
tilt fluid. <Refer to section 6.>
Remove 2 screws 5, and then remove yoke ass'y 4 from
2.
motor bracket ass'y 6.
3. Remove armature ass'y 7 from yoke ass'y 4.
2）Continuity Test
Check electrical conductivity of armature 2. Replace
1.
armature ass'y if other than specification.
Armature Conductivity :
3Commutator
4Armature shaft
14
Non-conductive
∞
1Yoke ass'y
2Screw
3Motor bracket
4Armature ass'y
4
1Meter
2Armature
3Commutator
4Armature ass'y
3
1
2
4
5
7
6
1
3
2
4st 9.9/15/20 2009