Monitor Session Mode - Dell C9000 Series Reference Manual

1 To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP on an
interface, verify that you are logged in to INTERFACE mode.
2 Enter the protocol lldp command. The prompt changes to include (conf-lldp) or (conf-if-interface-
lldp).
LLDP MANAGEMENT INTERFACE Mode
To enable and configure Link Layer Discovery Protocol (LLDP) on management interfaces, use LLDP
MANAGEMENT INTERFACE mode. For more information, see the
chapter in the Dell Networking OS Configuration Guide for the C9000 Series.
To enter LLDP MANAGEMENT INTERFACE mode:
1 Verify that you are logged in to LLDP mode.
2 Enter the management-interface command. The prompt changes to include (conf-lldp-mgmtIf).
LINE Mode
To configure the console or virtual terminal parameters, use LINE mode.
To enter LINE mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the line command. Include the keywords console or vty and their line number available on the
switch. The prompt changes to include (config-line-console) or (config-line-vty).
You can exit this mode by using the exit command.
MAC ACCESS LIST Mode
To enter MAC ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use
the mac access-list standard or mac access-list extended command.
To enter MAC ACCESS LIST mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Use the mac access-list standard or mac access-list extended command. Include a name
for the ACL. The prompt changes to include (conf-std-macl) or (conf-ext-macl).
You can return to CONFIGURATION mode by using the exit command.

MONITOR SESSION Mode

To enable and configure a traffic monitoring session using port monitoring, use MONITOR SESSION mode.
For more information, see
To enter MONITOR SESSION mode:
Port Monitoring.
Link Layer Discovery Protocol (LLDP)
CLI Basics 61