Service Call - Toshiba e-STUDIO206L Service Manual

8.2.2

Service call

Error code Classification
C010 Drive system
related service call
C040 Paper feeding
system related
service call
C130
C140
C150
C160
C180
C1A0
C1B0
C260 Scanning system
related service call
C261
C262
C270
C280
C290
C3D0 Process related
service call
C3D1
C3D2
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Contents
Main motor abnormality: The main motor is not rotating
normally.
PFP motor abnormality: The PFP motor is not rotating
normally.
Upper drawer tray abnormality: The upper drawer tray
motor is not rotating or the upper drawer tray is not
moving normally.
Lower drawer tray abnormality: The lower drawer tray
motor is not rotating or the lower drawer tray is not
moving normally.
PFP upper drawer tray abnormality: The PFP upper
drawer tray motor is not rotating or the PFP upper drawer
tray is not moving normally.
PFP lower drawer tray abnormality: The PFP lower
drawer tray motor is not rotating or the PFP lower drawer
tray is not moving normally.
LCF tray-up motor abnormality: The LCF tray-up motor is
not rotating or the LCF tray is not moving normally.
LCF end fence motor abnormality: The LCF end fence
motor is not rotating or the LCF end fence is not moving
normally.
LCF transport motor abnormality: The LCF transport
motor is not rotating normally.
Peak detection error: Lighting of the exposure lamp
(white reference) is not detected when power is turned
ON.
Peak detection error (high-light intensity):
(e-STUDIO207L/257/307/357/457/507 only)
Peak detection error (communication error):
(e-STUDIO207L/257/307/357/457/507 only)
Carriage home position sensor not turning OFF within a
specified period of time: The carriage does not shift from
its home position in a specified period of time.
Carriage home position sensor not turning ON within a
specified period of time: The carriage does not reach to
its home position in a specified period of time.
Scanner fuse blowout: 24V power for the scanning
system is not supplied at the scanner warming-up after
power-ON.
EPU board memory overwriting error: The overwriting of
the EPU board memory fails.
EPU board memory new parts detection error: The EPU
board detects the process unit as a new unit when the
equipment is started in the normal mode.
EPU board memory old parts detection error: The EPU
board cannot detect the new process unit when the
equipment is started in the EPU replacement mode ([7] +
[START]).
8 - 14
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Troubleshooting
P. 8-121
P. 8-122
P. 8-123
P. 8-123
P. 8-124
P. 8-124
P. 8-125
P. 8-126
P. 8-127
P. 8-128
P. 8-131
P. 8-134
P. 8-136
P. 8-138
P. 8-138
P. 8-139