Toshiba e-STUDIO206L Service Manual page 181

(3) Install the harness in the harness guide and
wire it to the rear side of the equipment.
(4) Fix the harness with 1 clamp, and fold the
harness back.
(5) After installing, move carriage-1 to the left
edge and confirm that there is no
abnormality such as a twisted lamp harness.
(6) Install the harness in the connector of the
lamp inverter board.
Notes:
When installing the harness, be careful not to
insert it at an angle.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-120
Xenon lamp LED
Fig. 4-121
Fig. 4-122
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 41
Lamp inverter board
DISASSEMBLY AND REPLACEMENT
4