Toshiba e-STUDIO206L Service Manual page 568

Error code Classification
E712 RADF jam
E714
E721
E722
E724
E725
E726
E731
E860
E870
E871
E910 Finisher jam
(Bridge unit)
E920
E930
E940
E950 Job separator jam
E951
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Contents
Jam not reaching the registration sensor: The
original fed from the original feeding tray does not
reach the registration sensor.
Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
Jam not reaching the read sensor: The original
does not reach the read sensor after it has passed
the registration sensor (when scanning obverse
side) or the reverse sensor (when scanning reverse
side).
Jam not reaching the exit sensor (during scanning):
The original which passed the read sensor does not
reach the exit sensor when it is transported from the
scanning section to exit section.
Stop jam at the registration sensor: The trailing
edge of the original does not pass the registration
sensor after its leading edge has reached this
sensor.
Stop jam at the read sensor: The trailing edge of the
original does not pass the read sensor after its
leading edge has reached this sensor.
Transport/exit signal reception jam: RADF receives
the transport/exit reception signal from the
equipment when no original is at the exposure
waiting position.
Stop jam at the exit sensor: The trailing edge of the
original does not pass the exit sensor after its
leading edge has reached this sensor.
RADF jam access cover open: The RADF jam
access cover has opened during RADF operation.
RADF open jam: RADF has opened during RADF
operation.
Cover open jam in the read ready status: Jam
caused by opening of the RADF jam access cover
or front cover while the RADF is waiting for the
scanning start signal from the equipment. (MR-
3021/3022)
Jam at the bridge unit transport sensor-1: The
paper does not reach the bridge unit transport
sensor-1 after it has passed the exit sensor.
Stop jam at the bridge unit transport sensor-1: The
trailing edge of the paper does not pass the bridge
unit transport sensor-1 after its leading edge has
reached the sensor.
Jam at the bridge unit transport sensor-2: The
trailing edge of the paper does not reach the bridge
unit transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-1.
Stop jam at the bridge unit transport sensor-2: The
trailing edge of the paper does not reach the bridge
unit transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-2.
Jam not reaching the job separator transport
sensor: The paper has passed through the exit
sensor does not reach the job separator transport
sensor.
Stop jam at the job separator transport sensor: The
trailing edge of the paper does not pass the job
separator transport sensor.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 8
Troubleshooting
P. 8-80
P. 8-80
P. 8-81
P. 8-81
P. 8-82
P. 8-82
P. 8-83
P. 8-83
P. 8-84
P. 8-84
P. 8-85
P. 8-86
P. 8-86
P. 8-87
P. 8-87
P. 8-88
P. 8-88