11.5.1
Scanner ROM (e-STUDIO206L/256/306/356/456/506 only)
Important:
•
Be sure to shut down the equipment before installing and removing the download jig.
•
Do not shut down the equipment during the update. The data could be damaged and not be
able to be operated properly.
[A] Update Procedure
(1)
Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2)
Press the [ON/OFF] button on the control panel to shut down the equipment and turn the power
OFF using the main power switch.
(3)
Take off the right upper cover.
* When the authentication screen appears, press [OK]. (Enter the password, if one has been
set.)
(4)
Take off the cover plate.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
FIRMWARE UPDATING
Right upper
cover
Fig.11-36
Cover plate
Fig.11-37
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
11 - 46