Precautions And Procedures When Replacing Sram Board - Toshiba e-STUDIO206L Service Manual

9.3.8

Precautions and Procedures when replacing SRAM board

Notes:
• Do not replace the HDD and the SRAM board together.
• Be careful not to damage the board when replacing the SRAM board.
• When the SRAM board is replaced, do not perform HDD partition creation (Format HDD)
before the normal start-up.
A procedure for replacing the SRAM board is shown below.
Notes:
"[G]Backup ADI key" is required only for the equipment in which the ADI-HDD has been installed.
Other procedures are the same as those for installing the SATA-HDD.
[A] Backup SRAM
Notes:
If "[A] Backup SRAM" fails, proceed to "[B]Return License".
(1) Install the USB media in the equipment, and then turn the power ON while pressing [5] and [9]
buttons simultaneously.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
START
[A]
[B]
[C]
[D]
[E]
[F]
ADI-HDD
SATA-HDD
[H]
[I]
[J]
[K]
[L]
[M]
[N]
[O]
END
Fig. 9-46
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
9 - 31
[G]
REPLACEMENT OF HDD/PC BOARDS
9