Paper Exit Tray Switching Settings - Toshiba e-STUDIO206L Service Manual

[ 1-5 ]

Paper exit tray switching settings

Set the switching timing of the paper exit from the movable tray to the finishing tray.
If the problem is not suppressed through Steps [1-1] to [1-4], perform the following steps.
(1) Turn OFF the power of the equipment.
(2) Remove 1 screw and take off the board access cover [1].
(3) Set the SW1 on the Finisher control board as shown in the figures below.
(4) Turn ON the power of the equipment while pressing the [0] button and the [8] button
simultaneously.
(5) Press [Button1] 11 times and then press [Button2] once.
(6) Press [Button1] 13 times and then press [Button2] once.
(7) Check the following list and press [Button1] as many times as noted for Adjustment value whose
switching timing you want to select.
Approx. 500 sheets with plain paper
(8) Press [Button2] once.
(9) Press [Button1] and [Button2] simultaneously.
(10) Turn OFF the power of the equipment.
(11) Turn OFF all bits of SW1 on the Finisher control board as shown below.
(12) Install the board access cover with 1 screw.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
[1]
Fig.6-118
Switching timing
0 sheet with plain paper
ON SW1
1 2 3 4
Fig.6-119
6 - 106
SW1
ON
1 2 3 4
SW1
Number of blinking times
1
3
ON SW1
1 2 3 4
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved