Toshiba e-STUDIO206L Service Manual page 266

4.14.3 Exit motor (M10)
(1) Take off the paper exit unit.
( P. 4-125 "4.14.2 Paper exit unit")
(2) Remote 2 screws and take off the duct.
(3) Release the harness from the harness
clamp.
Remove 1 screw and take off the motor
cover.
Notes:
When installing the motor cover, engage the
shaft of the motor cover and the bearing of
the gear.
(4) Disconnect 1 connector and take off the exit
motor and the heat sink.
Notes:
When installing the exit motor, make sure to
put on the timing belt.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
Gear
Timing belt
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 126
Duct
Fig. 4-359
Harness clamp
Motor cover
Fig. 4-360
Heat sink
Exit motor
Fig. 4-361