Lgc Board (E-Studio357/457/507); Mot Board (E-Studio207L/257/307) - Toshiba e-STUDIO206L Service Manual

9.2.4

LGC board (e-STUDIO357/457/507)

(1) Take off the rear cover
( P. 4-12 "4.2.6 Rear cover").
(2) Disconnect 16 connectors.
(3) Remove 4 screws and then take off the LGC
board [1].
Notes:
When replacing the LGC board, remove
IC29 from the old board and then install it on
the new one.
• When installing EEPROM (IC29)[2], be sure
that its pins are attached in the correct
direction and not misaligned.
• Do not touch the pins of EEPROM (IC29)[2]
with your bare hands. (Be careful of static
electricity.)
Replace the LGC board following  P. 9-28
•
"9.3.5 Procedures when replacing the LGC
board".
9.2.5

MOT board (e-STUDIO207L/257/307)

(1) Take off the rear cover
( P. 4-12 "4.2.6 Rear cover").
(2) Remove 1 screw, and take off the flywheel.
(3) Disconnect 4 connectors, remove 2 locking
supports and 2 screws, and then take off the
MOT board.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 9-29
Flywheel
Fig. 9-30
Fig. 9-31
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
9 - 11
MOT board
REPLACEMENT OF HDD/PC BOARDS
9