Toshiba e-STUDIO206L Service Manual page 1014

[B] Update Procedure
(1) Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2) Press the [ON/OFF] button on the control panel to shut down the equipment and turn the power
OFF using the main power switch.
(3) Remove 1 screw and take off the finisher board access cover.
<When MJ-1101 is connected>
<When MJ-1106 is connected>
(4) Release the latches and take off the rear lower cover of the hole punch unit.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
FIRMWARE UPDATING
Board access cover
Fig.11-50
[1]
Fig.11-51
Rear lower cover
Fig.11-52
11 - 58
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved