Right Upper Cover; Rear Cover - Toshiba e-STUDIO206L Service Manual

4.1.5

Right upper cover

(1) Remove 3 screws and take off the right
upper cover.
4.1.6

Rear cover

(1) Remove 5 screws. Lift up the rear cover and
then release 3 hooks on the upper side.
Then open the upper side of the rear cover
slightly toward you, and then take off the rear
cover by lifting it up.
Remarks:
When installing the rear cover, hang the 3
hooks of the rear cover on the frame of the
equipment, and then hang the 3 hooks on
the holes of the upper rear cover to fix it.
Then tighten 5 screws to fix it securely.
Notes:
When the Antenna (GN-3010, optional) is
installed, take it off first and then remove the
rear cover. Then hang the Antenna on the
protrusion of the upper rear cover so that it
will not fall off. If three Antennas are
installed, hang two of them on the upper rear
cover and then place the third one on the
other two.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-7
Rear cover
Fig. 4-8
Fig. 4-9
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 3
Right upper cover
DISASSEMBLY AND REPLACEMENT
4