Toshiba e-STUDIO206L Service Manual page 572

Error code Classification
EAE0 Finisher jam
EAF1
EAF2
EAF3
EB30
EB50 Paper transport jam
EB60
ED10 Finisher jam
(Finisher section)
ED11
ED12
ED13
ED14
ED15
ED16
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Contents
Receiving time-out jam: The printing has been
interrupted because of the communication error
between the equipment and finisher when the
paper is transported from the equipment to the
finisher.
Stack exit roller nip motor home position detection
error: The detection of the home position of the
stack exit roller nip motor ends abnormally. This
error may occur if paper is jammed while being
transported, so it is treated as a paper jam.
[MJ-1032/MJ-1033]
Stapler unit sliding motor home position detection
error: The detection of the home position of the
stapler unit sliding motor ends abnormally. This
error may occur if paper is jammed while being
transported, so it is treated as a paper jam.
[MJ-1032/MJ-1033]
Gripper arm motor home position detection error:
The detection of the home position of the gripper
arm ends abnormally. This error may occur if paper
is jammed while being transported, so it is treated
as a paper jam. [MJ-1033]
Ready time-out jam: The equipment judges that the
paper transport to the finisher is disabled because
of the communication error between the equipment
and finisher at the start of printing.
Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper.
Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper (redetection after no jam is
detected at [EB50]).
Skew adjustment motor (M1) home position
detection abnormality: The Skew adjustment motor
is not at the home position. [MJ-1101/1106 (when
MJ-6103 is installed), MJ-1107/1108 (when MJ-
6104 is installed)]
Sideways adjustment motor (M2) home position
detection error: The Sideways adjustment motor is
not at the home position. [MJ-1101/1106 (when MJ-
6103 is installed), MJ-1107/1108 (when MJ-6104 is
installed)]
Shutter home position error: The shutter is not at
the home position. [MJ-1101/1107/MJ-1106/1108]
Front alignment plate home position error: The front
alignment plate is not at the home position. [MJ-
1101/1107/MJ-1106/1108]
Rear alignment plate home position error: The rear
alignment plate is not at the home position. [MJ-
1101/1107/MJ-1106/1108]
Paddle home position error: The paddle is not at the
home position. [MJ-1101/1107/MJ-1106/1108]
Buffer tray home position error: The buffer tray is
not at the home position. [MJ-1101/1107/MJ-1106/
1108]
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 12
Troubleshooting
P. 8-108
-
-
P. 8-109
P. 8-109
P. 8-54
P. 8-57
P. 8-109
P. 8-110
P. 8-110
P. 8-111
P. 8-112
P. 8-113
P. 8-114