Replace parts
Feeding sensor (S22)
Junction box paper detection sensor
(S26)
Transport path-2 (S27)
Transport path-3 (S28)
Ejecting roller (S29)
Interface PC board (I/F)
Saddle stitcher controller board
Finisher controller board
[EAE0] Receiving time-out jam
Classification
Finisher jam
Proce
Check item
dure
1
Is the finisher working?
2
Are the versions of the
Finisher, Saddle Stitch
Finisher and converter
firmware the latest?
3
Parts to be replaced
Finisher controller PC board
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Receiving time-out jam
Result
Yes
Replace the finisher controller PC board.
No
Yes
Download the firmware in the latest version.
No
•
Check if the voltage (24V) is being supplied
to the finisher.
•
Check the connection of the LGC board and
IPC board
•
Check if the harness connecting the IPC
board and finisher I/F connector of the
equipment side is open circuited.
•
Check if the harness connecting the I/F
connector of the finisher side and finisher
controller PC board is open circuited.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 108
Remarks
Error content
Measure
Remark
Next
Step
2
3