(4)
Connect the download jig [1] to the jig connector (CN7) [8] on the finisher control PC board (FIN).
(5)
Turn the power ON with the main power switch while pressing the digital keys [0] and [8]
simultaneously.
Updating starts automatically and the LED on the download jig lights.
(6)
When the update is completed normally, the LED on the download jig starts blinking.
It is assumed that the update has failed if the LED does not start blinking even after 1 minute has
elapsed. In this case, shut down the equipment and check the following items.
Then clear the problems and restart the update from the beginning.
•
Is the downloading jig connected properly?
•
Is the ROM attached to the downloading jig properly?
•
Have the update data been written correctly to the ROM on the jig?
•
Is the download jig or the equipment damaged?
(7)
Turn OFF the power of the equipment and disconnect the download jig.
(8)
Install the download cover.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
[8]
Fig.11-42
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
11 - 51
FIRMWARE UPDATING
11