[EB60] Paper left on the transport path due to multiple feeding
Classification
Paper transport jam
Proce
Check item
dure
1
Open the Automatic
duplexing unit. Is there
any paper in front of the
registration sensor?
2
Is the registration sensor
working?
(Perform the input check
in the test mode: 03-
[FAX]OFF/[6]/[E])
3
Roller
Parts to be replaced
Registration sensor
LGC board
Rollers on the transport path
[E360] Paper fed from the PFP lower drawer not reaching the PFP upper drawer feed sensor
Classification
Paper transport jam
Proce
Check item
dure
1
Open the PFP side cover.
Is there any paper in front
of the PFP upper drawer
feed sensor?
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
The multiple feeding of preceding paper caused the misfeeding of
upcoming paper
Result
Yes
Remove the paper.
No
Yes
No
•
Check if the connector CN316 on the LGC
board is disconnected.
•
Check if the connector of the registration
sensor is disconnected.
•
Check if the connector pins are
disconnected and the harnesses are open
circuited.
•
Check if the conductor pattern on the LGC
board is short circuited or open circuited.
•
Replace the registration sensor.
•
Replace the LGC board.
•
Check the rollers. Replace them if they are
worn out.
Jam not reaching the PFP upper drawer feed sensor
Result
Yes
Remove the paper.
No
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 57
Error content
Measure
Remark
Error content
Measure
ERROR CODE AND TROUBLESHOOTING
Next
Step
2
3
8
Next
Step
2