Jsp Cover Opened During Printing - Toshiba e-STUDIO206L Service Manual

[E490] JSP cover opened during printing
Classification
Cover open jam
Proce
Check item
dure
1 Is the JSP cover open?
2 Is the JSP cover switch
working?
(Perform the input check
in the test mode: 03-
[FAX]ON/[3]/[E])
3 Replacing board
Parts to be replaced
JSP cover switch
JSP board
LGC board
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Job separator cover open jam
Result
Yes Remove the paper if there is any, then close
the cover.
No
Yes
No • Check if the connector of the JSP cover
switch is disconnected.
• Check if either of the connectors CN260 or
CN261 on the JSP board is disconnected.
• Check if the connector CN302 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the JSP
board and LGC board are short circuited or
open circuited.
• Replace the JSP cover switch.
• Replace the JSP board.
• Replace the LGC board.
• Replace the JSP board.
• Replace the LGC board.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 73
Error content
Measure
Remark
ERROR CODE AND TROUBLESHOOTING
Next
Step
2
3
8