Adjustment Of The Paper Feeding System; Sheet Sideways Deviation Caused By Paper Feeding - Toshiba e-STUDIO206L Service Manual

6.10 Adjustment of the Paper Feeding System

Adjust the laser writing start position in the primary scanning direction with the lower drawer. (05-4005,
05-4006)
If deviation still occurs, perform the following:
6.10.1

Sheet sideways deviation caused by paper feeding

<Procedure>
The center of the printed image shifts to the front
side.  Move the guide to the front side (Arrow
(A) direction in the lower figure).
Feeding direction
Fig.6-47
Bypass feeding
(1) Loosen the screw.
(2) Move the entire guide to the front or rear
side.
(3) Tighten the screw.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
[Rear]
Center
[Front]
6 - 62
The center of the printed image shifts to the rear
side.  Move the guide to the rear side (Arrow
(B) direction in the lower figure).
Feeding direction
Fig.6-48
(A)
Fig.6-49
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
[Rear]
Center
[Front]
(B)