9.2.6
MOT2 board (e-STUDIO357/457/507)
(1)
Take off the rear cover
( P. 4-12 "4.2.6 Rear cover").
(2)
Remove 1 screw, and take off the flywheel.
(3)
Disconnect 9 connectors, remove 4 screws,
and then take off the MOT2 board.
9.2.7
Switching regulator
Notes:
Be very careful of residual charge in the capacitors of the switching regulator; this may remain
even after the main power switch is turned OFF.
(1)
Take off the laser optical unit.
( P. 4-60 "4.8.1 Laser optical unit").
(2)
Take off the left cover
( P. 4-13 "4.2.11 Left cover").
(3)
(3) Remove 1 screw and take off the plate
[1].
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
REPLACEMENT OF HDD/PC BOARDS
Flywheel
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
9 - 12
Fig. 9-32
MOT2 board
Fig. 9-33
[1]
Fig. 9-34