Adjustment Of The Leading Edge Position - Toshiba e-STUDIO206L Service Manual

6.13.4

Adjustment of the leading edge position

Notes:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF. Also, the RADF position and height shall be adjusted properly.
[A] Checking
Check the image using the chart (original) with vertical and horizontal lines in the following procedure.
Simplex copying:
(1) Place the chart provided as an original with its face up on the original tray of the RADF, select [1
Sided -> 1 Sided] and press the [START] button.
(2) Superimpose the chart on the copy and check the leading edge E of the chart and F of the copy.
Duplex copying:
(1) Place the chart provided as an original with its face down on the original tray of the RADF, select
[2 Sided -> 2 Sided] and press the [START] button.
(2) Superimpose the chart on the copy and check the leading edge E of the chart and F of the copy.
Fig.6-95 Chart (Original)
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
E
6 - 81
F
Fig.6-96 Copy
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
6