Toshiba e-STUDIO206L Service Manual page 330

(36) Attach the harness to the connector of the
fuse board and the one of the frame of the
equipment.
(37) Connect the harness coming from the clamp
to the connector.
(38) Apply 1 hook to the frame of the equipment.
(39) Attach the harness to the connector, and
then fix the drum damp heater with 1 screw.
Notes:
• After the scanner damp heater and drum
damp heater have been installed, perform
the installation following the opposite
procedure of the disassembly.
• Check the following after the installation
of the damp heater
1. Image quality
2. Abnormal heating
3. Any screws not installed
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
Fuse board
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 190
Fig. 4-543
Fig. 4-544