Toshiba e-STUDIO206L Service Manual page 1080

Sub
05/08 Mode Element
element
05 Adjustmen Scanner RADF
t mode
05 Adjustmen Scanner RADF
t mode
05 Adjustmen Scanner RADF RADF leading edge
t mode position adjustment
05 Adjustmen Scanner RADF Leading edge position
t mode adjustment
05 Adjustmen Scanner Scanner
t mode
05 Adjustmen Scanner Scanner
t mode
05 Adjustmen Scanner Scanner Data transfer of
t mode characteristic value
05 Adjustmen Scanner Scanner
t mode
05 Adjustmen Printer Printer Fine adjustment of
t mode polygonal motor
rotation speed
e-STUDIO206L/256/306/356/456/506
Item Subitem Code
3042
3043
3044
3045
3046
3047
3203
3209
Adjustment of primary 4000
scanning direction
reproduction ratio
Sub- Default Acceptable
Details
code value value
Fine adjustment of 50 0~100
RADF transport
speed
RADF sideways 128 0~255
deviation adjustment
Front side 50 0~100
Back side 50 0~100
Carriage position 128 0~255
adjustment during
scanning from RADF
(black)
Carriage position 128 0~255
adjustment during
scanning from RADF
(color)
SLG board -> SYS -
board
Data transfer of -
characteristic value of
scanner / SYS board -
> SLG board
PPC 130 0~255
4
RAM Contents
SYS When the value increases by "1", the reproduction ratio
of the secondary scanning direction when using the
RADF increases by approx. 0.1%.
SYS When the value increases by "1", the image of original
fed from the RADF shifts toward the rear side of paper
by approx. 0.08423 mm.
SYS When the value increases by "1", the copied image of
original fed from the RADF shifts toward the trailing
edge of paper by approx.0.2 mm.
SYS When the value increases by "1", the copied image of
original fed from the RADF shifts toward the trailing
edge of paper by approx.0.2 mm.
SYS When the value increases by "1", the carriage position
shifts by approx. 0.1 mm toward the exit side when
using the RADF.
SYS When the value increases by "1", the carriage position
shifts by approx. 0.1 mm toward the exit side when
using the RADF.
SYS Transfers the characteristic values of the scanner
(shading correction factor / RGB color correction /
reproduction ratio color deviation correction / shading
position correction factor / reproduction ratio correction
value in primary scanning direction)
SYS Transfers the characteristic values of the scanner
(shading correction factor / RGB color correction /
reproduction ratio color aberration correction / shading
position correction factor / reproduction ratio correction
value in primary scanning direction)
M When the value increases by "1", the reproduction ratio
of primary scanning direction increases by approx.
0.07%. (approx. 0.1 mm/step)
Proc Service
edure UI
1 Yes
1 Yes
1 Yes
1 Yes
1
1
6 Yes
6
1 Yes