Job Separator Jam; Jam Not Reaching The Jsp Feed Sensor; Stop Jam At The Jsp Feed Sensor - Toshiba e-STUDIO206L Service Manual

[ 2 ] Job separator jam

[E950] Jam not reaching the JSP feed sensor
[E951] Stop jam at the JSP feed sensor
Classification
Job separator jam
Proce
Check item
dure
1 Open the JSP cover. Is
there any paper on the
transport path?
2 Is the JSP feed sensor
working?
(Perform the input check
in the test mode: 03-
[FAX]ON/[3]/[D])
3 Replacing board
Parts to be replaced
JSP feed sensor
JSP board
LGC board
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Jam not reaching the job separator transport sensor
Stop jam at the job separator transport sensor
Result
Yes Remove the paper.
No
Yes
No • Check if the connector of the JSP feed
sensor is disconnected.
• Check if either of the connectors CN260 or
CN262 on the JSP board is disconnected.
• Check if the connector CN302 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the JSP
board and LGC board are short circuited or
open circuited.
• Replace the JSP feed sensor.
• Replace the JSP board.
• Replace the LGC board.
• Replace the JSP board.
• Replace the LGC board.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 88
Error content
Measure
Remark
Next
Step
2
3