Toshiba e-STUDIO206L Service Manual page 973

Notes:
• The display of items on this screen varies depending on the types of data written on the USB media.
Each item is displayed only when each data file is written on the USB media in the following
conditions.
Item
1. SYSTEM
FIRMWARE(OS Data)
2. ENGINE
FIRMWARE
3. SCANNER
FIRMWARE
4. SYSTEM
SOFTWARE (HD Data)
5. RADF FIRMWARE
6. FINISHER
FIRMWARE
7. SADDLE
FIRMWARE
8. PUNCH FIRMWARE
• If the USB media are not recognized properly, "USB device Not detected" message is displayed. In
this case, disconnect the USB media and connect again within 3 minutes, or shut down the
equipment and connect the device properly. Then repeat the procedure from (4).
• If any of the error messages below is displayed, confirm if the data file in the USB media is correct.
Then repeat the procedure from (4).
Error
number
01 Error Loadmodule
02
Machine Model Get Error
03 Copy Data with valid signature in USB
Storage
04 Other models ROMDATA TXXXXXXXX
* The version name comes at
"xxxx.xxx.x".
05 Copy Signature File in USB Storage
06 Patch and Normal package in one folder of
USB Storage
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO206L/256/306/356/
456/506
T160SF0Wxxxx.tar is written.
(xxxx is version.)
T160MWW.xxx or
T165MWW.xxx is written. (xxx is
version.)
T160SLGWW.xxx is written. (xxx
is version.)
T160HD0Wxxxx.tar and
T160SY0Wxxxx.tar are written.
(xxxx is version.)
502DFWW.xxxx is written. (xxxx
is version.)
-
-
-
Error message
11 - 17
Condition
e-STUDIO207L/257/307/357/
457/507
T330SF0Wxxxx.tar is written.
(xxxx is version.)
TH330MWW.xxx or
TH335MWW.xxx is written.
(xxx is version.)
TH330SLGWW.xxx is written.
(xxx is version.)
T330HD0Wxxxx.tar is written.
(xxxx is version.)
H614DFWW.xxx is written.
(xxxx is version.)
FIN1107T.xxx is written. (When
MJ-1107 is connected.)
FIN1108T.xxx is written. (When
MJ-1108 is connected.)
(xxxx is version.)
SDL1108T.xxx is written. (When
MJ-1108 is connected.)
(xxxx is version.)
PUN6104T.xxx is written. (When
MJ-6104 is connected.)
(xxxx is version.)
Cause
Module loading failed.
Model information was not
downloaded.
Checking of data file failed.
Master data of other model are
stored.
Data files are not stored in the USB
media.
When both the system and patch
update packages are in the USB
media
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
FIRMWARE UPDATING
11