Toshiba e-STUDIO206L Service Manual page 894

3. ID=05 and c5
ID Name
05 Re-allocated Sector Count
c5 Current Pending Sector Count The number of candidate sectors to
4. Description of each ID
ID Name
01 Read Error Rate
02 Throughput Performance
03 Spin Up Time
04 Spin Start/Stop Count
05 Re-allocated Sector Count
07 Seek Error Rate
08 Seek Time Performance
09 Power-On Hours
0a Spin Retry Count
0c Power Cycle Count
c0 Power off Retract Count
c1 Load Cycle Count
c2 Temperature
c3 ECC On the Fly Count
c4 Reallocation Event Count
c5 Current Pending Sector Count
c6 Off-Line Scan Uncorrectable Sector Count
c7 Ultra DMA CRC Error Count (Rate)
c8 Write Error Rate
Notes:
"Over-range" appears when the digits of the numbers obtained from HDD exceed the acceptable
limit for being displayed on the touch panel. This is not shown as a failure.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
REPLACEMENT OF HDD/PC BOARDS
Description
The number of sectors reassigned
be reassigned
This attribute is a measure of the read error rate.
This attribute is a measure of the throughput performance.
This attribute is a measure of how quickly the drive is able to
spin up from a spun down condition.
This attribute is a measure of the total number of spin ups
from a spun down condition.
This attribute is a measure of the total number of reallocated
sectors.
This is a measure of the seek error rate.
This attribute is a measure of a drive's seek performance
during normal online operations.
This attribute is a measure of the total time (hours or minutes
depending on disk manufacturer) the drive has been on.
This attribute is a measure of the total number of spin retries.
This attribute is a measure of the number of times the drive
has been turned on.
This attribute is a measure of the total number of emergency
unloads.
This attribute is a measure of the total number of load/
unloads.
This attribute is a measure of the temperature in the HDD.
This attribute is a measure of the total number of the ECC On
the Fly.
This attribute is a measure of the total number of the
reallocation events.
This attribute is a measure of the total number of candidate
sectors to be reallocated.
This attribute is a measure of the total number of
uncorrectable sectors found during the off-line scan.
This attribute is a measure of the total number of errors found
in data transfer in the Ultra-DMA mode.
This attribute is a measure of the write error rate.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
9 - 18
Remarks
This value tends to increase at
HDD failure.
This value tends to increase at
HDD failure.
Meaning