Toshiba e-STUDIO206L Service Manual page 1023

(8) Connect the download jig with the jig connector (CN9) on the Finisher control board.
(9) Turn the power ON using the main power switch while simultaneously holding down the [0] and
[8] buttons.
Updating starts and the LED on the download jig lights.
(10) When the update completes normally, the LED on the download jig starts blinking.
The LED on the download jig starts blinking approx. 20 seconds after the update started.
It is assumed that the update has failed if the LED does not start blinking even after 30 seconds
have elapsed. In this case, shut down the equipment and check the following items. Then clear
the problems and restart updating from the beginning.
• Is the downloading jig connected properly?
• Is the ROM attached to the downloading jig properly?
• Have the update data been written correctly to the ROM on the jig?
• Is the download jig or the equipment damaged?
• Is the harness jig for board connection connected to connector (CN2) of the converter PC
board and the connector (CN15) of the finisher control PC board correctly?
(11) Press the [ON/OFF] button on the control panel to shut down the equipment and turn the power
OFF using the main power switch.
(12) Remove the download jig and the harness jig for board connection from the finisher control PC
board.
Notes:
Be sure to secure the connection cable in the connector (CN15) of the finisher control PC board
when the hole punch unit (MJ-6103) has been installed.
(13) Install the board access cover.
(14) Remove the harness jig for board connection from the converter PC board.
(15) Install the converter PC board in the equipment.
(16) Install the rear cover of the equipment.
[B] Confirmation of Firmware Version
Be sure to install the converter PC board in the equipment and connect the finisher (MJ-1101) before
confirming the firmware version of the converter firmware.
 P. 11-81 "11.7 Confirmation of the updated data"
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Download jig
Fig.11-64
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
11 - 67
FIRMWARE UPDATING
11