Backup Function; Data Cloning - Toshiba e-STUDIO206L Service Manual

12. BACKUP FUNCTION

12.1 Data Cloning

12.1.1 General description
Data cloning is a function that backs up user data, setting data and SRAM data into a USB media and
also restores these data into the equipment.
This function backs up or restores the data of the same equipment (same serial number), and is
performed in the following cases.
- When the SYS board and the SRAM board are replaced at the same time.
- When the SRAM board is replaced.
12.1.2 Precautions
• When the ADI-HDD is initialized or replaced, back up the SRAM data afterwards.
• It is assumed that data cloning is to be performed when equipment is installed or options are
installed. If the address book has been registered, do not perform restore. Registered / set data are
lost.
• The USB media for the data cloning must meet the following conditions. A data cloning operation
with any devices other than the following will not be guaranteed.
- A combination USB media with a flash memory (to be connected directly to the USB port) and its
capacity is 1GB or more.
- A device compliant with the following specifications established by USB-IF (USB Implementers
Forum)
Class number:
Sub-Class number:
Protocol number:
- Most of the common USB medias are compliant with the above specifications and are therefore
applicable to this data cloning. However, most of these devices were originally developed to be
used in an environment for PCs (e.g. Windows or Macintosh) and thus operations exclusively
with this equipment have not been fully guaranteed. Therefore, the user must thoroughly check
in advance whether there will be any problem in operating with this equipment when adopting
one of these devices.
• The USB medias compliant with both USB 1.1 and USB 2.0 can be used for this data cloning.
• Data cloning with any storage devices other than a flash memory (e.g. USB-connectable memory
card reader, CD/DVD drive, hard disk) will never be guaranteed. Therefore never use them for this
operation.
• Be sure to unplug the LAN cable and Fax line before data are backed up / restored. Also, do not use
the RADF and open the cover, drawer, etc. during the data cloning.
• Data can be backed up / restored only for the same model and version. If the version is different,
update the firmware and back up / restore data in the same version.
• Restore data to equipment which has the same options as when the data are backed up.
• Delete the backed up data in the USB media after the data cloning.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 (=08h) (Mass storage class)
6 (=06h) (SCSI transfer command set)
80 (=50h) (Bulk-only)
12 - 1
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
BACKUP FUNCTION
12